Smithy Ez-Trol2 Instrukcja Użytkownika Pobierz pdf (Strona 58)

10G04 P5.0

lock 10 causes the machine to dwell (G4) for a period of five seconds. This allows the spindle to

get up to speed before drilling begins.

N11G43Z1.H1

Block 11 turns on tool length compensation (G43) and moves the drill to a position 1” above the top

surface pf the part using the tool length offset for the first line of the tool table.

N12G83R.1Z-.7Q.0391F6.85M08

Block 12 selects a chip-break drilling canned cycle, also known as peck drilling, G83. R.1 tells the

machine to retract the drill bit .1” above the surface after each “peck”. The machine drills down to

Z-.7. Each peck feeds the drill down .039 inches further with each peck (Q.039) at a feed rate of 6.85

inches per minute with the coolant on (M08).

N13X2.55

Block 13 follows the same pattern established when the first hole was drilled. This line moves to

X2.55 and drills the second hole.

N14G80M09

Block 14 cancels the G83 canned drilling cycle (G80) and turns the coolant off (M09).

N15G00G49Z1.M05

Block 15 rapidly retracts the drill to a position 1” above the top surface of the part and cancels the

tool offset (G49). Finally, the spindle is turned off with command M05.

N16G04 P5.0

Block 16 shows that the axis movement stops by applying the dwell command (G04) for a period of

5 seconds.

N17G00X0Y0

Block 17 rapidly moves the tool to the position X0 Y0, which is the tool change position, selected

by he programmer

(*** T2 *** .250 End mill ***)

This is a comment line telling the operator to change to Tool 2.

N18M00T2M06

Block 18 pause the machine, (M00), allowing time for the tool change just as done for tool one. After

the operator presses the “Resume” button, program execution continues.

N19G00X1.325Y1.075S5000M03

Block 19 moves rapidly (G00) to the position of X.1325 Y1.075 at the spindle speed of 500 with the

spindle turning in the forward direction.

w SmithyCNC EZ-Trol II Control System

52 | Toll Free 1-800-476-4849

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 82 83

Brak uwag

Smithy Ez-Trol2 Instrukcja Użytkownika Strona 58